Comments

Document Feedback - Review and Comment

Step 1 of 4: Comment on Document

How to make a comment?

1. Use this Protected Document to open a comment box for your chosen Section, Part, Heading or clause.

2. Type your feedback into the comments box and then click "save comment" button located in the lower-right of the comment box.

3. Do not open more than one comment box at the same time.

4. When you have finished making comments proceed to the next stage by clicking on the "Continue to Step 2" button at the very bottom of this page.

 

Important Information

During the comment process you are connected to a database. Like internet banking, the session that connects you to the database may time-out due to inactivity. If you do not have JavaScript running you will recieve a message to advise you of the length of time before the time-out. If you have JavaScript enabled, the time-out is lengthy and should not cause difficulty, however you should note the following tips to avoid losing your comments or corrupting your entries:

  1. DO NOT jump between web pages/applications while logging comments.

  2. DO NOT log comments for more than one document at a time. Complete and submit all comments for one document before commenting on another.

  3. DO NOT leave your submission half way through. If you need to take a break, submit your current set of comments. The system will email you a copy of your comments so you can identify where you were up to and add to them later.

  4. DO NOT exit from the interface until you have completed all three stages of the submission process.

 

Vocational Education and Training procedure

Section 1 - Preamble

(1) This Procedure was approved by Academic Board on 14 August 2012 and incorporates all amendments to 27 October 2014.

Top of Page

Section 2 - Purpose

(2) This Procedure documents the University's Vocational Education and Training (VET) course endorsement process.

Top of Page

Section 3 - Scope

(3) This Procedure applies to Vocational Education and Training awards offered by the University through DeakinCo.

Top of Page

Section 4 - Policy

(4) This Procedure is pursuant to the Vocational Education and Training policy.

Top of Page

Section 5 - Procedures

(5) DeakinCo. requests the addition or removal of a VET course via a memo to the Chief Operating Officer and the Deputy Vice-Chancellor Education.

(6) After considering the request, the Chief Operating Officer provides approval based on business or strategic grounds and the Deputy Vice-Chancellor Education provides approval based on academic quality standards.

(7) DeakinCo. then submits a formal application for amendment of its RTO scope of registration to the National VET Regulator (NVR).

(8) The NVR considers the application for amendment on the basis of its academic merit and DeakinCo.'s compliance with the VET Quality Framework (VQF). At the discretion of the NVR, scope extensions may depend on the outcome of an external audit conducted by the NVR.

(9) Upon the successful addition of the course to DeakinCo.'s scope of registration on the National Register, DeakinCo. submits an application to the Chair, Academic Board for endorsement of the course as a University Award.

(10) The Chair, Academic Board will consider endorsing the course as a University Award based on the academic approval previously provided by the NVR and the Deputy Vice-Chancellor Education.

Top of Page

Section 6 - Definitions

(11) For the purpose of this Procedure:

  1. Course: as defined in Regulation 5.2(7) - Vocational Education and Training Courses
  2. National VET Register: as defined in the Vocational Education and Training policy
  3. National VET Regulator (NVR): as defined in the National Vocational Education and Training Regulator Act 2011 (Cth)
  4. Nationally Endorsed Training Package: as defined in Regulation 5.2(7) - Vocational Education and Training Courses
  5. VET Quality Framework (VQF): as defined in Regulation 5.2(7) - Vocational Education and Training Courses.